Snowflake
Model do druku 3D

Print ready Snowflake.



Measure units are millimeters, the figure is about 25 mm in width.


Mesh is manifold, no holes, no inverted faces, no bad contiguous edges.

Available formats: .blend, .stl, .obj, .fbx, .dae

Here is three versions of the model:

1) SF_TwoSides. (blend, .obj, .fbx, .dae. stl) This files contain the snowflake that is both sided and the bail as a separate object. The model consists of 298956 triangular faces.

2) SF_OneSide. (blend, .obj, .fbx, .dae. stl) This files contain the snowflake that is flat at back side and the bail as a separate object. The model consists of 171052 triangular faces.

3) M_Head_op_hlw. And here is low poly version of model. 17988 faces, but 20364 triangles.

For stl there is versions without bail.