Helix Test Cube - Filament Sample - XYZ Calibration 무료 3D 모델

$0.00
제거 이 아이템 북마크
  • 이용 가능한 포맷:
    stl: stl 1.15 MB
  • 애니메이티드:
    No
  • 텍스쳐드:
    No
  • 리그드:
    No
  • 재료:
    No
  • 로우 폴리곤:
    No
  • 컬렉션:
    No
  • UVW 매핑:
    No
  • 플러그인 사용 됨:
    No
  • 프린트 준비:
  • 3D 스캔:
    No
  • 성인용 콘텐츠:
    No
  • PBR:
    No
  • 지오메트리:
    Polygonal
  • 언래핑 된 UVs:
    Unknown
  • 조회:
    2976
  • 날짜:
  • 아이템 ID:
    387211
  • 평점:
Summary
I wanted to have a test print which I can use to test the dimensional accuracy of my printer and the print quality of my filaments. But it should also be pretty enough to keep as a color sample afterwards. So I created this 30x30x30 mm cube which contains several functions.
The print takes about 1.5 hours.

You can check the following properties on this cube:

stringing
bridging (are the bridges over the letter clean, including the large area inside?)
ghosting / ringing
overhangs
dimensional accuracy in all axes
first layer height (is the logo clearly visible on the underside, are there holes in the narrow areas?)
Was the helix printed neatly with a single wall line?
Are there problems with the Z-seam due to the many retraction?
Was the Z printed neatly on the top?
You can also try breaking out the Y, if that is too easy you may have to reduce the cooling or increase the printing temperature.

Print Settings
Rafts:
No

Supports:
No

Resolution:
0,2

Infill:
15
Avtor modeli: Extrutim
다른 포맷이 필요하세요?
다른 포맷이 필요하시면, 새로운 지원 티켓을 열어 요청하세요. 저희는 3D 모델을 다음으로 변환할 수 있습니다: .stl, .c4d, .obj, .fbx, .ma/.mb, .3ds, .3dm, .dxf/.dwg, .max. .blend, .skp, .glb. 우리는 3D 장면을 변환하지 않습니다 .step, .iges, .stp, .sldprt와 같은 형식도 포함됩니다.!

다운로드 Helix Test Cube - Filament Sample - XYZ Calibration 무료 3D 모델 stl 발신 bagros111

bridge print filament test calibration hobby diy
이 아이템에 대한 코멘트 없음.