anetam8undercoverremastered 3D 프린트 모델

a total new remix from the old anet8 and the newer am8 conversion with a 2040 alu. extrusion

2040 alu extrusion lengths are 3 x 310 mm 2x 340 mm 2x 440 mm

all pieces are newly designed for more strengt and easy printing.
included is a bowden setup, but you can easy use a direct drive system. i designed it so you could use your anet 8 old hardware or order new hardware on the various site's.

if you want this printed by me drop me a line.

3d printing settings
best results with 0.2 layer
small pieces 100% infill
bigger between 30 and 50 % depending on the material.
i printed everything in pla but pteg works also fine 프린트 준비: 아니오