Church CS in N gauge Model Cetak 3D

3D MODEL DESCRIPTION
This is a church building, based on the beautiful church in the town of Cerro Sombrero, Chile. It is made up of the structure, the access, windows and doors, ornaments, roofs and a priestly office building connected by a corridor. The real building has panels on its roofs which are reproduced to scale in this model.

The scale is 1:150 which makes it suitable for model electric trains in N scale. It is made up of several STL files compressed in a single ZIP file.

Dimensions:

Base measurements: 24.4 x 18 cm.
Building measurements: 23.2 x 17.4 x 9.2 cm.

Main features of the model:

The building can be printed on any type of printer, as versions have been made for both 20x20 and larger volumes, and continuous printers.

Two church bells are included which go under the bell tower in "V" of the access.

Version of the structure of the church and offices complete as well as plates. Print according to taste or type of printer.

Easy assembly since it is only enough to observe the renders. There are joints that connect certain elements, such as the main cross to the structure or to form the bases.

STL files categorized and arranged in folders where the files of each version are arranged. There is a folder that has all the shared parts for all versions.

Supports: Set to print without supports in general but in the main structure, it is recommended to occupy supports despite being in plate format. It will also require support for the base of the back cross and a few other pieces (check before printing).

It is recommended to print in PLA material and in the best possible quality (0.1 mm).

Recommended colors: structure in red, church door in light blue, doors in brown, ceilings in white (the one in the church can also be light blue), pavements and stairs in grey, ornaments in white.

Optimized for printers of any type.

Although the holes are designed for the correct insertion of windows and doors, the highest quality should still be used to print the latter, and the holes may need to be sanded or polished if necessary.

Glue should be used to attach windows, doors, base and roof, preferably UHU.

3D PRINTING PARAMETERS
Extrusion temperature: 195-200º
Material: Any, but preferably PLA
Bed temperature: 55-60º
Does it require support?: No, only in the main structure and some parts (check).